Cutmaker 351LE – 230V Single Phase
Main features include;
- Superior cut quality with really clean straight edges on all materials from the thinnest sheet right up to max capacity.
- Cuts clean or dirty & rusty material just as well, steel, galv steel, stainless steel, hard ox, aluminium, brass, copper etc
- Thermal gouging function allows the operator to gouge away material efficiently, ideal for removing welds, fastenings, edge plates brackets etc
- Thermal arc heating function allows the operator to apply direct thermal arc heating similar to using gas bottles but using only air & electric!
- Metal marking function for both hand & cutting tables, mark your logo, fold points, date codes etc.
- 351 model now includes an accurate dial to show power setting in amps.
- Energy efficient design 90%+ efficiency means you get more cutting power for the lowest input power.
- Class leading air consumption, as much as 50% lower than competition means only a small compressor needed & the lowest possible fumes.
- Bullet proof design means this machine will be unaffected by varying input power or unstable generator.
- 6M torches with long life low cost consumables.
- Now rated to IP23S protection so can be used in your workshop or even outside in light rain.
- Built in air filter to help trap moisture & particles with regulator & pressure gauge to allow easy setting of air.
- NON HF design means these are safe for use on vehicles & around IT based equipment.
- Easy fit CNC interface kit now available, upgrade for cutting table use etc.
- All CUTMAKERS are composed of over 95% metal with minimal plastics, built tough & kinder to environment.
- Built in UK! Built to last! To BS EN60974-1, BS EN60974-10, BS EN60974-7, RoHS, WEEE & CE marked.
Specifications include;
- Supply Voltage/ fuse: 230V 1~ 16A (13A OK for most use)
- Max Severance cut capacity: 20mm steel
- Clean quality cut up to: 15mm
- Pierce capacity: 9mm
- Max cutting power output: 5KW
- Max cut speed 6mm steel: 1100mm/min
- Max cut speed 10mm steel: 520mm/min
- Max cut speed 15mm steel: 260mm/min
- Min generator rating for ¾ output: 4KVA
- Recommended generator rating: 5.5KVA
- Air pressure & flow rate: 65-70 psi 3.5CFM
- Duty cycle at ½ power & below: 100% continuous
- Duty cycle at full power: 40%
- Weight approx: 34kg
- Machine size (steelwork size): 250mm x 420mm x 500mm
This machine can be used on lower input supplies with reduced cutting capacity, 16A to 60% cut power, 13A plug to around 50% cut power.